#Savant truecontrol mac android#

of the iOS or Android device running the Savant App.īelow is a network diagram showing the Savant 1.x entertainment package.

During initial setup or when adding devices to the network, ensure that any devices being added are within 30 ft.

The IR Blaster communicates with the local Wi-Fi network through the Remote Base.

Each device added can now communicate with the Savant Host over the local Wi-Fi network.

The User now adds each additional device using Bluetooth to the local Wi-Fi network through the Savant App.

The Host can now communicate with the local Wi-Fi network.

The iOS or Android device communicates with the Savant Host using Bluetooth through the Savant App and provisions the Host to the local Wi-Fi network.

Locate Device Status LEDs and Reset Buttonsīelow is a network diagram showing the setup process. The device is responding to a Locate command sent to it from the Savant App. In this state, the device is ready to be added to a local Wi-Fi network. After the reset, the rapid red blink will stop change to solid yellow, and then to a slow blinking yellow. The device has been reset and will return to its factory default settings.

#Savant truecontrol mac update#

Do Not unplug the device until the software update is complete. The device is receiving a software update over the local Wi-Fi network. If the blinking remains constant, the device is connected to the local Wi-Fi network but not the Savant Host. The device is connecting to your network and establishing communication with the Savant Host or Savant App. The device is ready to be connected to the local Wi-Fi network The device has established communication with both the local Wi-Fi network and Savant Host. More than 1 minute – Device can't locate the Wi-Fi network it was formerly connected to. The state will change once boot is complete. The Savant 1.x products use the following codes on their LED status lights. Host communicates with the IP Cloud using port 443.Sonos speakers communicate with host using port 3401.

Multicast packets are broadcast on port 1900. UDP packets are broadcast on ports 914.

Do not utilize a Guest Network to set up the various Savant devices to a network.Therefore, all devices communicating with a Savant device must be added to the same subnet (Ex: 192.168.1.xxx). All Savant devices use self-discovery methods.Network should employ one of the network security formats shown above.Ensure that the network router can handle the additional IP Addresses that will be added through the Savant network.

#Savant truecontrol mac install#

Install network repeaters or extenders to ensure a robust network wherever Savant products are installed.In some instances, testing the reliability using one of the various available network performance analyzer Apps may be required. Ensure UDP/TCP between the local network and the Savant devices are reliable.Allow UDP and TCP traffic between the following:.Do not block or restrict UDP broadcasts.Network Packet Shaping, Traffic Shaping, QoS, and other Bandwidth Management techniques are NOT recommended.Local Wi-Fi® Network Security – WPA1™, WPA2™, WPA1™ + WPA2™, WEP.Local Wi-Fi® Network supporting 2.4 GHz (802.11 b/g/n).

#Savant truecontrol mac how to#

After reading this guide, you will have a better understanding and be more informed of how the Savant 1.x system operates, what possible common snags can occur, and how to fix these issues. The information in this guide should be read and understood in its entirety prior to contacting the Savant Support Team.

This Network Troubleshooting Guide can be used to troubleshoot any problems that may occur during setup or normal use. The SAV-REM-KIT1-00 entertainment package uses a local Wi-Fi® network to operate. Savant 1.x Remote and Host Entertainment Package To access the link to the topics in this document, click the topic text. 1.x Network Troubleshooting Guide Document Number: